RNode and supported boards
An RNode is a radio interface for a host running Reticulum, such as the Ratspeak app. The host handles the network and messages; the RNode sends and receives radio packets. RNode is an open system implemented on several boards, not one particular manufacturer's device. See the upstream RNode overview.
RNode uses LoRa radio modulation without LoRaWAN. A LoRaWAN gateway or sensor is not automatically an RNode: it needs compatible hardware and RNode firmware.
Radio for a host, or standalone messenger?
Choose an RNode if you want to add a LoRa connection to an app or computer. Choose a Standalone handheld if you want to read and send messages on the device itself. Ratspeak Handheld's Full package includes both modes and a launcher for switching between them.
The Ratspeak Handheld v2.3.5 release provides these images:
| Device | Released modes | Hardware detail |
|---|---|---|
| LilyGO T-Deck Plus | Full, Standalone, RNode | Use the image for T-Deck Plus. |
| LilyGO T-Pager | Full, Standalone, RNode | The released target uses the SX1262 radio. |
| M5Stack Cardputer Adv | Full, Standalone, RNode | LoRa requires the Cap LoRa-1262 module. |
| ThinkNode M9 | Standalone | This release has no M9 Full or RNode image. |
The release downloads and flashing guide identify each package. Do not use an image for a similarly named board or substitute an older rsDeck, rsPager or rsCardputer image in the current installation procedure.
Other RNode boards
Upstream RNode firmware has its own device support and release list. Use its
automated installer,
rnodeconf-rs -a from rsReticulum,
or the RNode tab on the
Ratspeak advanced flasher to check the exact
variant. Select the board revision and hardware band; do not choose by the
radio chip name alone.
For Heltec LoRa32, follow the browser tutorial or rnodeconf tutorial. Upstream labels its Heltec firmware experimental, so a listed installer target should not be read as a production qualification.
Before choosing hardware, check:
- Exact model and revision: firmware and pin assignments can differ between revisions of the same product.
- Radio band and antenna: both must cover the frequency you intend to use.
- Host connection: confirm the firmware and your host platform support the intended USB, Bluetooth or network connection.
- Power and enclosure: include the cable, battery or supply and the physical protection needed at the installation site.
Price and quoted maximum range do not establish whether a board will work in your location. See antennas, range and power.
Connect an RNode to Ratspeak
On a host that supports USB serial, use a USB data cable for a first connection and close any flasher or serial monitor that has the port open. A handheld must be running RNode mode when used as the host's USB/BLE radio.
Add an RNode interface in the app, select its connection and configure the radio for the other nodes you intend to reach. Follow LoRa and RNode for the complete setup and matching radio parameters. A successful serial connection alone does not prove radio reachability; announce and exchange a message with a known peer.